
16
RailKing 4-Car Subway Set Operating Manual
RAILKING
again. If the bell doesn’t’t function when you press the button, you may
need to re-program ProtoSounds to operate with a separate bell button
controller. To do this enter
RESET and go to Feature 20.
(See the section Using RESET
To Program ProtoSounds®on
page 14.) Once in Feature 20,
press the whistle button and
wait for the module to sound a
bell ding(s). Continue pushing
the whistle button until the
module plays back two dings
(signifying that the module has
been programmed for a bell
button). Simply turn the throttle
off and then on again to
“Lock-In" the new setting.
To turn the bell button
function off, repeat the
above procedure but keep
pushing the whistle button
until the computer only
responds with one bell
ding.
PROGRAMMING FOR SQUEAKING BRAKE
OPERATION
ProtoSounds® can be programmed for squeaking brake operation in three
different manners; (1)Squeaking brakes can be activated by bell button
control, (2)they can be programmed for continuous operation subject to
throttle changes or (3)they can be programmed to be turned off. The default
setting is (2) Squeaking
brakes are activated for
full-time operation as
described on page 6. To
change the default setting,
enter RESET and go to
Feature 45. (See the
section Using RESET To
Program ProtoSounds®
Clank, Clank, Clank,
Clank, Clank, Etc.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
45 Times
Listen For 9 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear The
Appropriate # Of Dings
Interrupt The Throttle
To “Lock-In”
The Brake Setting
H
Common
RED Wire
BLACK Wire
U
A
U
B
U
C
U
D
Clank, Clank, Clank,
Clank, Clank
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
20 Times
Listen For 5 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear 2 Dings
Interrupt The Throttle
To “Lock-In”
The Bell Button Setting
H
Comentarios a estos manuales